I Have a problem with the way the g2 "Vision" charts display on my Oregon 400.
I have both an Oregon 400 and a 76CSx. The g2 Vision charts display fine on my 76CSx but on the Oregon 400 I see the Satelllite View wherever it it is availabel within the g2 Vison charts. If I take the detail leverl down to Less or Least, the diaplay shows up as a normal chart. But otherwise, when I go back up to the Normal or above detail level, I get the satellite picture again.
I tried a different g2 vision charts and it was the same results. It was fine on the 76CSx but not on the Oregon 400.
Since these charts were obtained in a less than proper method, I hesitate to report this to Garmin, but it obviously a problem with the Oregon 400 firmware/software. I tried going several different firmware versions, 3.82beta, 3.80, 3.60 all with the same results.
I am disappointed as the g2 vision charts do definately display more info, including street names on the charts. But with the satellite view, it renders the chart useless for any real navigation.
Has anyone else had this experience with their units?
Acoording to Garmin, the 76CSx and Oregon 400 units are "Compatible" wiht the Vison charts, but not all the feature are available. Well.... I wish the satellite view wasn't available w=either.
Thanks for any feedback.