I have unlocked and installed the safety cameras in to Garmin following the instructions provided, and when I near a safety camera I get a message that flags up in the centre of the screen that warns me of this. However, on the map there is no icon to represent it, is this normal? if not can you please advise how I can install cameras with an actual icon?

Should the safety cameras be showing in the POI'S?

Garmin safety cameras not show if you only browse maps you must create route and simulate it then it show cam icon

pietu wrote:Garmin safety cameras not show if you only browse maps you must create route and simulate it then it show cam icon

Hi again pietu, how do I simulate a route? - do you mean that the camera icon will only work if I am actually using the device i.e navigating to a particular address or postcode physically or is there a way I can actually simulate a route without actually going anywhere?

Also on a side note, to make you aware, I was sandboxed yesterday and whilst I was on this site I was automatically taken to another site (one of you sponsors pop up) which flashed up as a false antivirus scan, whilst I was there it tried to install several trojans on my machine, which was evident through sandbox. I will wait until it does it again then I will send you the details.

what is you device ?

eg. my nuvi 200
1. do garmin simulate this way... get gps off (this must do all gps take off gps)
settings\system\gps simulator put it on
2. go start page "where to\browse map" select start point (near safety cam) "set loc" and go back
3. browse map and select end point and push "GO"
4. it ask you "do you want to simulate...." press yes

send virus info to user named "admin"

Thats it you have done it again, everything is working 100% well done and thankyou.

Can I ask one more question? do I have to install lane assistance seperately or is that on the map you supplied in your other post on my other thread?

lane assistant not works all device
eg. nuvi 200 not support it