Change of unit

Sun Jun 17, 2012 7:57 am

Hi All
I have primo 2 running on a Chinese wince5 as per lower part of my sig.I have just sold my motorhome and this unit will go with it.The question is,i will be buying a 1 din unit with the same spec or higher,if i make a copy of the sd card will I be able to just put it in the new unit or will i be better to download the complete primo and maps to start a fresh.

Thanks

Sun Jun 17, 2012 8:11 am

Unless you have modified something specifically for your first hardware, Primo is not device-specific so just copying the setup for a newer device should work. If you have specific settings in your sys.txt, just remove them before installation in the new unit. Starting over can be a bit of a bother if it's not required.

Sun Jun 17, 2012 8:30 am

IGO is not device specific as well, just for the record.
But it could be wise to not only delete device specific settings in sys.txt, but to delete the save folder as well. The hardest part then will be to set up the soft again.
Just my 2cts.

Sun Jun 17, 2012 8:59 am

Thank you guys,as always you gave me the answers. :clap:

First I have to buy another motorhome then I will post a few links on here re advice as to the single din unit i will want to buy. :dance:

Tue Jun 19, 2012 8:34 am

Thread_closed

Tue Jun 19, 2012 9:02 am

Thread officially closed

THREAD_CLOSED