Hi
I'm not a fan of stancy's branding . Most reasons are lots of files/icons twice ,even three times
Anyway your issue is in pictures.icon
In old igo all files bmp and spr are in common folder so in files .icons you have : $poi_mapclose.spr
In primo all files bmp and spr are in résolution folder so in files .icons you must have : poi_mapclose.spr
In his primo branding Stancy go on with $poi_mapclose.spr ( all bmp and spr in common ) . No problem if all instrutions are coherent
But for 2.4 in ui_igo9/icons/poi Stancy added a file pictures.icon directly copied from data 2.4 so with instructions poi_mapclose.spr . no surprise Primo don't find poi_mapclose in résolution folder
So in pictures.icon you have just to replace poi_XXXX.spr by $poi_XXX.spr as you see in multipoi.icon

I don't suppose anyone has managed to solve the issue with the icon pack under 800x480 ?

Any new skin revisions since 1.7.1 ?

Thanks.

just read my post above
the issue is the pack not the skin

chtonio wrote:Hi
I'm not a fan of stancy's branding . Most reasons are lots of files/icons twice ,even three times
Anyway your issue is in pictures.icon
In old igo all files bmp and spr are in common folder so in files .icons you have : $poi_mapclose.spr
In primo all files bmp and spr are in résolution folder so in files .icons you must have : poi_mapclose.spr
In his primo branding Stancy go on with $poi_mapclose.spr ( all bmp and spr in common ) . No problem if all instrutions are coherent
But for 2.4 in ui_igo9/icons/poi Stancy added a file pictures.icon directly copied from data 2.4 so with instructions poi_mapclose.spr . no surprise Primo don't find poi_mapclose in résolution folder
So in pictures.icon you have just to replace poi_XXXX.spr by $poi_XXX.spr as you see in multipoi.icon

Had the same problem, changed the file names as suggested and all now works OK:clap:

I know this is a bit of an old thread now but I have just experienced the same and think I may have found a solution...

In the ui_igo[x]/common folder, create a folder called "night".

Copy the "missing" file(s) from the common folder to the folder you have just created ("common/night").

Just to make sure, I copied all the files starting "poi_" (e.g. "poi_mapclose", "poi_group" etc.) and that seemed to have fixed the problem.

If you do this, don't forget to copy both the .bmp and corresponding .spr file.