Newbie here.
I'm running an in dash 7" all in one unit. I've been following the assorted threads concerning loading iGO8 and Primo by SD card. I've been successful in hacking the unit and have
MioPocket, iGO8, & Destinator running. I've gotten the Primo to get as far as displaying the map but then get the "run out of memory" pop up. I've tried to load Primo alone, not
using the MioPocket at all, but get the same result. I've gone in and slid the memory allocation to the left, same story. Is there any way of trimming down Primo to be able to get
it functioning?

Thanks,

Jim

CosmicArkie wrote:Newbie here.
I'm running an in dash 7" all in one unit. I've been following the assorted threads concerning loading iGO8 and Primo by SD card. I've been successful in hacking the unit and have
MioPocket, iGO8, & Destinator running. I've gotten the Primo to get as far as displaying the map but then get the "run out of memory" pop up. I've tried to load Primo alone, not
using the MioPocket at all, but get the same result. I've gone in and slid the memory allocation to the left, same story. Is there any way of trimming down Primo to be able to get
it functioning?

Thanks,

Jim

Do you have Primo and iGO8 on the same card?
Try putting the following in sys.txt in Primo.

[folders]
has_secondary_root=0