Hello, I decided today to upgrade my 2 DIN nav (400mhz, 64mb, 800x480) from Primo 1.1 (which worked perfectly, without a single crash for 4 months) to 1.2. I downloaded it from
http://www.navitotal.com/forums/showthread.php?6383-iGo-Primo-1.2-Optimized-for-Europe-but-can-be-used-anywhere . I don't use TTS, I edited the sys.txt, installed it on my MMC, started it. It works, when I'm in the menus, settings, everything works. But when I go to the map screen (in 3d, the map is visible, but in the distance its disturbingly blurred) after 4-5 seconds the nav restarts, without error message. I installed GJ skin 3.10, the nav simply exits from Igo. I played with sys.txt, no change.
What should I do?
My sys.txt:
[debug]
skip_eula=1
experimental_features=1
hide_win_taskbar=1
usenightmode_tunel=1
autosave=1
[gps] ;You have to put your unit values for port, baud, source
port=2
baud=57600
source="nmea"
[interface]
show_exit=1
extra_settings=1
resolution_dir="800_480"
vga=0
show_tmc_config=1
show_tmc_eventlist=1
show_programs=1
laneinfo_signpost_enabled=1
[map]
3d_tunnels=1
3d_roads=1
3d_dem_detail=3
show_blockroad=1
show_oneway=1
[sound]
csv_voice_enabled=1
[other]
demo_enabled=0
[vr]
disabled=1
[Warning]
is_spoken=1
send_warn_event=1
speedcam_visualtype=1
speedcam_soundtype=0
[sound]
maneuver_chimes=0
ding=0
queue_length=200
suspend_time=200
use_os_volume=1
[sound.announcer]
gps_signal_lost=0
gps_disconnected=0
[navigation]
junction_view_at_maneuver=1
[feature]
signpost_coloring=1
Thanks!