Hi all, I just installed my third Chinese 2 DIN head unit (Eonon G2213D) that came with Sygic GPS software. But in my other two setups I use igo8 software, I prefer it to Sygic.
Anyway, when I try to run igo8 in my new head unit it will not load.
I reset the path to Storagecard, igo8, igo8.exe.
I reboot the system and the GPS does try to load. I opens up to the main screen where it starts loading all the goodies, then it gets to "Starting" and comes to a halt. After a couple minutes it cycles through again to the same point. After a few more attempts I get an error message telling me that it failed to start on the last attempt and asks if I want to set it back to it's default "YES" or "NO". It doesn't matter which I chose it just goes back into the same vicious loop of trying to load over and over again untill that same error message pops up. It's obvious that the path is correct and the OS sees the .exe file, but it just will not load. Can you shed some light on this. Thanks