Hi all; I've just updated a mate's Go 300 with the SE navcore 8.412.1336, and added the UK 870.3406 maps.

I've ran Tomtom home and updated mapshare etc.

Problem is, when I turn the unit on, it thinks i'm about 20 miles away from where I actually live. Even if I set it to navigate to a destination, it still thinks the starting point is the wrong map location.

Is there any way to update the satellite list?

Any thoughts on how to correct this?

Cheers

Hotpants

Hotpants wrote:Is there any way to update the satellite list?

Give this attached TT-QuickGPSFix patch a go.

Hi, I have already replied to this thread, but nothing is showing up, so rather than run the risk of appearing to be rude and ungrateful for the excellent help, I am resubmitting.
I copied 3 files from an old ephem backup on a different unit, and copied them into the Go300. As soon as the unit booted up, it found 8 satellites (I believe 4 is the minimum to get a good signal lock).

Tomtome home still does not show up quickfix, maybe because the Go300 uses a Sirfstar ll chipset and not a Sirfstar lll?

Thanks for the help as ever.

Hotpants

Hotpants wrote:1. I have already replied to this thread, but nothing is showing up.
2. Tomtome home still does not show up quickfix, maybe because the Go300 uses a Sirfstar ll chipset and not a Sirfstar lll?

1. Over the weekend, Navitotal switched to a new server. There was a small hiccup & some posts were lost. Yours might have been 1 of them.
2. Good call. I apologize for not catching that.

Ah, that explains it then :). No need for apologies tendriver, I am grateful as always for the help given. You can close this thread :)

Regards

Hotpants

Hotpants wrote:I am grateful as always for the help given.

It is our pleasure to help. Enjoy!!

THREAD_CLOSED