go 530 not working?   

go 530 not working?

Postby minterno » Fri Apr 15, 2011 5:45 pm

Hi guys,this is my first post on this forum so first of all i would like to say hi to everyone first so hi,im after getting a tomtom go530 from the brother but its not starting up properly,as it starts up i get a pic of the device with a memory card with a red x on it and thats as far as it will go,when i connect to either my laptop or desktop i keep getting the message device driver faild to install,yet when i check in the device manager it says the drivers are up to date and working,so i cant get in to the device and am stuck and could use some advice on where to go from here,the sat nav was never dropped or damaged so im hoping its just a software problem and if anyone has and ideas for me that would be great,cheers
minterno offline


Junior Member



 
Joined: Fri Apr 15, 2011 12:21 pm
Posts: 23
Has thanked: 0 time
Been thanked: 0 time

Postby tendriver » Fri Apr 15, 2011 6:25 pm

On the bottom of the case, there is a small reset hole. Stick a small wire or paper clip in the hole & hold it for thirty seconds, then try to connect to your computer.
tendriver offline


User avatar Ex Super Mod



 
Joined: Thu May 20, 2010 4:43 pm
Posts: 12005
Has thanked: 339 times
Been thanked: 627 times

Postby minterno » Fri Apr 15, 2011 7:09 pm

thanks for the reply tendriver but that didn't work for me,regards
minterno offline


Junior Member



 
Joined: Fri Apr 15, 2011 12:21 pm
Posts: 23
Has thanked: 0 time
Been thanked: 0 time

Postby PiEtU » Fri Apr 15, 2011 7:16 pm

minterno wrote:thanks for the reply tendriver but that didn't work for me,regards


Try to remove all other USB devices and try again and try all USB ports also or try other computer if you have....
device driver error can be USB power problem too...
PiEtU offline


User avatar Elite Member



 
Joined: Sat Feb 13, 2010 9:59 pm
Posts: 929
Location: Pitcairn Islands
Has thanked: 0 time
Been thanked: 164 times
Age: 59

Postby minterno » Fri Apr 15, 2011 7:50 pm

thanka PiEtU,i have tried all the usb ports but still no joy,i think its a problem with the sat nav as i have a laptop and a pc and still no joy and my brother had the same problem with his pc but thought it might be the computer being so old and outdated,the same problem on 3 different computers points to the device being the problem,its not being recognised as a usb mass storage device so i cant get into it to see if its a software problem,the unit is about 2 years old and was only used twice for about an hour each time so it would be a right bummer if its crokked.regards
minterno offline


Junior Member



 
Joined: Fri Apr 15, 2011 12:21 pm
Posts: 23
Has thanked: 0 time
Been thanked: 0 time

Postby PiEtU » Fri Apr 15, 2011 7:54 pm

minterno wrote:thanka PiEtU,i have tried all the usb ports but still no joy,i think its a problem with the sat nav as i have a laptop and a pc and still no joy and my brother had the same problem with his pc but thought it might be the computer being so old and outdated,the same problem on 3 different computers points to the device being the problem,its not being recognised as a usb mass storage device so i cant get into it to see if its a software problem,the unit is about 2 years old and was only used twice for about an hour each time so it would be a right bummer if its crokked.regards


you have SD-Card slot your device?, try to connect tomtom with sd-card...if you have luck it works with sd-card and you can install all to card
tendriver know that better??...
PiEtU offline


User avatar Elite Member



 
Joined: Sat Feb 13, 2010 9:59 pm
Posts: 929
Location: Pitcairn Islands
Has thanked: 0 time
Been thanked: 164 times
Age: 59

Postby PiEtU » Fri Apr 15, 2011 8:09 pm

I found this also:
[Please Register or Login to download file]
PiEtU offline


User avatar Elite Member



 
Joined: Sat Feb 13, 2010 9:59 pm
Posts: 929
Location: Pitcairn Islands
Has thanked: 0 time
Been thanked: 164 times
Age: 59

Postby minterno » Fri Apr 15, 2011 9:08 pm

thanks PiEtU,I tried the soft reset earlier and again just now but no joy but when the wife gets in from work i think she has a suitable memory card some where and i will give that a go,thanks for the ideas and help,i will let you know either way when i try it but it will be tomorrow id say before i can try it out,cheers
minterno offline


Junior Member



 
Joined: Fri Apr 15, 2011 12:21 pm
Posts: 23
Has thanked: 0 time
Been thanked: 0 time

Postby minterno » Fri Apr 15, 2011 9:58 pm

you were spot on with trying the memory card PiEtU,i took the card out of my nuvi1310 put in in an adaptor as its a mini one and bingo,the tomtom software recognised it and loaded in a lot of updates,now the card has garmin maps on it and i think it was just the card in the slot and not the dummy one that was in there that activated the tomtom,now all i need is to find out how to load the maps and pick the right ones,thanks a bunch for all the help,i thought it was a gonner for a while and am relieved to see a bit of life in it,happy days,regards
minterno offline


Junior Member



 
Joined: Fri Apr 15, 2011 12:21 pm
Posts: 23
Has thanked: 0 time
Been thanked: 0 time

Postby tendriver » Fri Apr 15, 2011 11:40 pm

minterno wrote:the tomtom software recognised it and loaded in a lot of updates,now the card has garmin maps on it


Please explain this Garmin map comment.
tendriver offline


User avatar Ex Super Mod



 
Joined: Thu May 20, 2010 4:43 pm
Posts: 12005
Has thanked: 339 times
Been thanked: 627 times

Postby minterno » Sat Apr 16, 2011 12:03 am

i used the micro memory card from my garmin nuvi 1310 in an adaptor and inserted it in to the tomtom and when i restarted the tomtom,tomtom home which was open at the time recognised the device and asked if i wanted to update the tomtom,which i did,prior to this i had a dummy memory card that came with the tomtom in the device.i still may have problems as the tomtom home updates installed to the memory card and not the tomtom disc,when i figure what maps i need i will install them on the memory card and hope i can either put them on the tomtom root or see if the maps will work from the memory card,i still cant get in to the tomtom hard disc,im like a blindman at the moment,feeling my way about,a few hours ago it wouldn't turn on,now its on and asking for maps,ie telling me no maps are found,tomorrow i will install the maps if i can and see what happens,thanks for the help tendriver,time for bed here,good night
minterno offline


Junior Member



 
Joined: Fri Apr 15, 2011 12:21 pm
Posts: 23
Has thanked: 0 time
Been thanked: 0 time

Postby tendriver » Sat Apr 16, 2011 1:02 am

minterno wrote:i used the micro memory card from my garmin nuvi 1310 in an adaptor and inserted it in to the tomtom and when i restarted the tomtom, tomtom home which was open at the time recognised the device and asked if i wanted to update the tomtom,which i did,prior to this i had a dummy memory card that came with the tomtom in the device.i still may have problems as the tomtom home updates installed to the memory card and not the tomtom disc,when i figure what maps i need i will install them on the memory card and hope i can either put them on the tomtom root or see if the maps will work from the memory card,i still cant get in to the tomtom hard disc,im like a blindman at the moment,feeling my way about,a few hours ago it wouldn't turn on,now its on and asking for maps,ie telling me no maps are found,tomorrow i will install the maps if i can and see what happens,thanks for the help tendriver,time for bed here,good night


1. Are you trying to access the internal memory with Windows Explorer?
2. So you can breath a little easier, when a card, that has a navcore & map loaded on it, is inserted into the device, the card becomes the default memory. If the internal memory is bad, it's no big deal, as long as the unit recognizes the card.
tendriver offline


User avatar Ex Super Mod



 
Joined: Thu May 20, 2010 4:43 pm
Posts: 12005
Has thanked: 339 times
Been thanked: 627 times

Postby minterno » Sat Apr 16, 2011 5:50 pm

sorry for the delay in answering you but i was out all day at a funeral and am not back long, to answer yor questions,'1. Are you trying to access the internal memory with Windows Explorer,i cant get in to the device at all,either there is a faulty disc in the tomtom or software issues,it wont reset either.
2when a card, that has a navcore & map loaded on it, is inserted into the device, the card becomes the default memory. If the internal memory is bad, it's no big deal,this is what i am hoping for,i will try the maps on the card when i figure out how and what map i need,regards
minterno offline


Junior Member



 
Joined: Fri Apr 15, 2011 12:21 pm
Posts: 23
Has thanked: 0 time
Been thanked: 0 time

Postby tendriver » Sat Apr 16, 2011 6:09 pm

minterno wrote:this is what i am hoping for,i will try the maps on the card when i figure out how and what map i need,regards


You could ask!!

When you attempt to start the 530 while it's in it's charging cradle, which is plugged into your computer, does the 530 ask if you want to connect to the computer?
tendriver offline


User avatar Ex Super Mod



 
Joined: Thu May 20, 2010 4:43 pm
Posts: 12005
Has thanked: 339 times
Been thanked: 627 times

Navcore.8.351.9982,which maps?

Postby minterno » Sat Apr 16, 2011 6:14 pm

hi guys,i hope im not double posting here,i have Navcore.8.351.9982 on a tomtom go 530 and i want to install the uk and ireland or european maps on it,i have had a good look around the site but im still a bit confused as to what i need to do,is there a step by step guide for dummies,im looking for the map number and instructions on how to install it on my unit/memory card,regards
minterno offline


Junior Member



 
Joined: Fri Apr 15, 2011 12:21 pm
Posts: 23
Has thanked: 0 time
Been thanked: 0 time

Next

Return to General Discussions about TomTom

 


  • Related topics
    Replies
    Views
    Last post

Who is online

Users browsing this forum: No registered users and 34 guests