Hello guys,
I need help, I downloaded the navcore 9151 prepared by NC from this page for my XL tomtom IQ Route edition, actually works very well, and I installed the loquendo be perfect.
I only have one problem, when I insert a path keeps it in memory until you turn off the tomtom, that is if I stop and I turn it on again I have to replace the destination ...
You know how I can fix it?

vidilo wrote:Hello guys,
I need help, I downloaded the navcore 9151 prepared by NC from this page for my XL tomtom IQ Route edition, actually works very well, and I installed the loquendo be perfect.
I only have one problem, when I insert a path keeps it in memory until you turn off the tomtom, that is if I stop and I turn it on again I have to replace the destination ...
You know how I can fix it?

Have you got the mode set to: "xliq" = XL IQ == x40light2

Where can I see or modify this configuration?
In the file "reskin" says "start2"

vidilo wrote:Where can I see or modify this configuration?
In the file "reskin" says "start2"

http://www.navitotal.com/forums/showthread.php?5506-latest-NC-prepared-for-small-and-large-devices

Read about configuring, then download configuration.zip.

Ok Tendriver,
I downloaded the configuration and i have installed the correct and now it's all perfectly.
Too bad that so I lost the status bar to 3 fields.

Thanks very much for your assistance.

vidilo wrote:Ok Tendriver,
I downloaded the configuration and i have installed the correct and now it's all perfectly.
Too bad that so I lost the status bar to 3 fields.

Thanks very much for your assistance.

You are Welcome.

Did you lose the 3 section status bar or gain it?

Exactly, with the configuration XL IQ Route works all round, however, is, aesthetically, with the status bar in two areas of dark blue.
With the configuration "start2"had the status bar with three fields of blue, typical of the start models.
For my taste, I liked it better even if the menu of the IQ Route XL is more complete.

Thanks for your quick help.