Forum- Contact •
- FAQ •
- Register •
- Login
- View unanswered posts • View active topics
-
Board index ‹ GPS Utilities & Unlock ‹ GPS Unlock ‹ Mio Device Unlock
Run Tomtom on Mio Moov and Navman S series (and some F serie
by Fatboyfun » Wed May 16, 2012 9:17 pm
FileFactory make it difficult, but not impossible to get maps, I find just refreshing the page every few seconds until a download slot becomes available works.
Currently sleeping...
by NRT » Sat May 19, 2012 10:10 pm
Try deleting Autorun.mscr. I had a miomoov 300 that would not detect gps device untill i deleted this file, but then the backlight is not at it's maximum. If this fixes your problem then you may need to use miopocket to unlock the mio with as they seem to have worked out how to fix the problem and still have the baclight working.
by Fatboyfun » Sat May 19, 2012 10:23 pm
No GPS device means the hardware hasn't been detected, Usually it's Other NMEA Receiver, Baud 4800 and COM:2/SirfNavDrv depending on the model.
It will always be Other NMEA receiver
I have seen other guides suggesting using baud rates of 57600 and 115200 so try those
Tomtom lists the available COM ports during setup, It's usually COM:2 or SirfNavDrv if available
Lastly is this a Spirit model?
It will always be Other NMEA receiver
I have seen other guides suggesting using baud rates of 57600 and 115200 so try those
Tomtom lists the available COM ports during setup, It's usually COM:2 or SirfNavDrv if available
Lastly is this a Spirit model?
Currently sleeping...
by Yurbuh Tuggly » Sun May 20, 2012 9:41 am
teac532s wrote:It runs version 6
There 'ya go.
TomTom will always have difficulty on any system with WinCE 6.x, and for that reason is usually not recommended.
Can you get it running by jumping through a lot of hoops? Yes.
Will it always be kludgy, unreliable, and prone to errors? Yes.
-
Yurbuh Tuggly
offline
- Joined: Wed May 04, 2011 7:25 am
- Posts: 1410
- Location: Politzania
- Has thanked: 0 time
- Been thanked: 797 times
by Fatboyfun » Sun May 20, 2012 10:44 am
Use this instead, http://www.navitotal.com/showthread.php?8169-Run-iGO-Primo-1.2-on-Mio-Moov-and-Navman-S-series-(and-some-F-series)-in-ten-steps.
Primo can set the backlight itself and runs quite happily under wince 6
Primo can set the backlight itself and runs quite happily under wince 6
by iceb33r » Wed Jun 20, 2012 11:46 am
Hi. My first post here.
Everything went well till step 7. From Step 8 as the link for autoactivate is no longer available I installed fast activate and continued with instructions. After running fast activate and disconnecting the device, when I start TOMTOM it still comes up in french and If I go to third page by clicking "Suivant" I get an error saying "Cannot find iexplore(or one of its components). Make sure the ath and filename are correct and that all the requireed libraries are available"
My DEVICE
S90i NAVMAN
WINCE 5.0 (Do I need to update this?? IF SO how?)
I was using Australia Map 885 4095.
PLEASE HELP!!!
Everything went well till step 7. From Step 8 as the link for autoactivate is no longer available I installed fast activate and continued with instructions. After running fast activate and disconnecting the device, when I start TOMTOM it still comes up in french and If I go to third page by clicking "Suivant" I get an error saying "Cannot find iexplore(or one of its components). Make sure the ath and filename are correct and that all the requireed libraries are available"
My DEVICE
S90i NAVMAN
WINCE 5.0 (Do I need to update this?? IF SO how?)
I was using Australia Map 885 4095.
PLEASE HELP!!!
-
iceb33r
offline
- Joined: Fri Jun 15, 2012 10:48 am
- Posts: 10
- Has thanked: 0 time
- Been thanked: 0 time
by NRT » Wed Jun 20, 2012 9:57 pm
iceb33r wrote:
My DEVICE
S90i NAVMAN
WINCE 5.0 (Do I need to update this?? IF SO how?)
I was using Australia Map 885 4095.
PLEASE HELP!!!
Map 885 4095 is the wrong map, try 885 4022 Also have sent you a PM.
by iceb33r » Thu Jun 21, 2012 11:31 am
@NRT - I have copied the Navigator you sent me and also copied the 885 4022 Map.
Now it is in English, but cannot detect the Map. On Clicking "next" it says that I can download 1 free map of my choice and the next page says how it can be done i.e via GPRS and Active Sync. When you click "next" I get an error saying cannot find iexplore(or one of its components). Make sure the path and filename are correct and that all the requireed libraries are available". How do I get around this??
And why cant the device find the Map?
Now it is in English, but cannot detect the Map. On Clicking "next" it says that I can download 1 free map of my choice and the next page says how it can be done i.e via GPRS and Active Sync. When you click "next" I get an error saying cannot find iexplore(or one of its components). Make sure the path and filename are correct and that all the requireed libraries are available". How do I get around this??
And why cant the device find the Map?
-
iceb33r
offline
- Joined: Fri Jun 15, 2012 10:48 am
- Posts: 10
- Has thanked: 0 time
- Been thanked: 0 time
-
- Related topics
- Replies
- Views
- Last post
-
- Help needed with tomtom 7 on mio moov 330
by avrel820 » Sat Jul 23, 2016 2:40 pm - 1 Replies
- 2181 Views
- Last post by holyhead
Sat Jul 23, 2016 3:07 pm
- Help needed with tomtom 7 on mio moov 330
-
- Install IGO or TomTom on Mio moov M416
by brucetheboss » Tue May 17, 2016 1:38 pm - 1 Replies
- 2778 Views
- Last post by holyhead
Tue May 17, 2016 4:47 pm
- Install IGO or TomTom on Mio moov M416
-
- Mio Moov 330
by Toy4wd » Tue May 03, 2011 11:54 am - 1 Replies
- 5349 Views
- Last post by chas521
Tue May 03, 2011 1:19 pm
- Mio Moov 330
-
- [SOLVED] What can i do with Mio moov 200
by romg93 » Mon Sep 10, 2012 12:49 pm - 3 Replies
- 4377 Views
- Last post by Fatboyfun
Tue Sep 11, 2012 1:27 pm
- [SOLVED] What can i do with Mio moov 200
Who is online
Users browsing this forum: No registered users and 3 guests
News
Site map
SitemapIndex
RSS Feed
