Mon Jul 23, 2012 5:10 am
destiny246 wrote:But still the "command and control" option is grayed out.
Mon Jul 23, 2012 4:32 pm
tendriver wrote:Confirm you have an active TTS voice in 9.430.
Mon Jul 23, 2012 5:18 pm
destiny246 wrote:Yes, I am using Loquendo TTS which I copied from navcore 9.051, which is working perfectly fine....
Another thing I noticed this morning while driving is after changing the Model x40light to model x40, RDS/TMC receiver doesn't work at all ( meaning there is no sidebar when I connect my receiver). It used to work fine when It was model x40light.
Mon Jul 23, 2012 6:33 pm
Tue Jul 24, 2012 3:45 pm
tendriver wrote:Fixing TMC reception with NC 9.4xx
Tue Jul 24, 2012 3:49 pm
destiny246 wrote:Yes, I am using Loquendo TTS which I copied from navcore 9.051, which is working perfectly fine....
Tue Jul 24, 2012 5:22 pm
tendriver wrote:Are you up to starting over?
Tue Jul 24, 2012 5:27 pm
Hamish wrote:I do not get the Traffic bar with 9.430. The 'replacement' mctx.dat (installed according to the instructions - 30+sec hard reset/run clearflash - has not brought up the Traffic bar.
Sorry for delay in checking, I was abroad and RDS/TMC antenna in UK.
Tue Jul 24, 2012 6:10 pm
destiny246 wrote:@tendriver - I have SE 9.430 but I don't know how to emu x40 or x50. And what are the exact steps to make the voice command work on 9.430. I am amazed that it works on 9.051 but not on 9.430.
destiny246 wrote:Yes I don't mind doing that. I'm willing to do anything as long as I get voice command and RDS/TMC starts working. Thanks
Wed Jul 25, 2012 9:13 am
destiny246 wrote:I don't know if you modyfied anything or not but in your configuratio folder is the model set to x40light?? Because mine works fine if model is set to x40light but if change to x40 or x50 rds tmc stops working. If nothing helps try to redownload the 9.430 from tendrivers post and it should work fine. I hope this helps