yes. and dont work.

tendriver wrote:Do you have a usable navcore & map combination for your Start??

hpscorpion wrote:yes. and dont work.

Then the correct answer is NO, You do not have a usable navcore & map combination for your Start.
I'll get back to you later.

why do you say that? I tested navcores specifically for my gps.
and installed the original navcore by tomtom home does not work. I have a problem. right?

hpscorpion wrote:why do you say that? I tested navcores specifically for my gps.

Simple. If it doesn't work, then it in't usable!! If you have a ttgo.bif file in the root of your start, open it with notepad & paste the contents into a PM to me.

I do not have that file. the tomtom does not start, does not create this file

hpscorpion wrote:I do not have that file. the tomtom does not start, does not create this file

Problem SOLVED. It is impossible to do the required patching without a ttgo.bif from your Start. Did you make a copy of the setup that was on your Start before you started the upgrade project?? If YES, then copy that ttgo.bif file into your unit.

I thought that file was automatically created.
I did not backup. can you help me make this file?

hpscorpion wrote:1. I thought that file was automatically created.
2. I did not backup.
3. can you help me make this file?

1. A new ttgo.bif file is created EVERYTIME the device is booted.
2. Two very important things to remember: ALWAYS make a copy & paste back-up. NEVER format your device unless told to do so by an expert!!
3. 9.101 might have gone far enuf into the boot cycle to have created a ttgo.bif file. Take a look in the 9.101 folder. If no file, then download, unzip & run [Please Register or Login to download file] Send the results + the .pna & .meta files of your new map to me in a PM.