News of General Discussions about iGO core - Page 152

Hope someone can help.

I have an Xtrons D710G 800x480 that runs Wince5 and not sure how much memory this unit has. Igo Primo 1.2 and loads fine. It calculates if i go to an address but as soon as i click on the map i get out of memory errors and it closes. I dont have any DC, dem, poi's or even speed cameras loaded as i deleted the files. Voice is just got ...

Hello again all,

I don't seem to have had too much luck with this update to 1.2, if it aint broke don't fix it as they say.

The speedcam files do not seem to be working anymore, iGO creates the normal .spud filesm etc, but when I'm actually using the GPS and driving around there are no speed camera warnings but there used to be in 1.1 in the same locations.

I am using the ...

I run Primo 1.2 on a chinese HU (WD6050) with a Nowada GPS board (WinCE6, 500Mhz, 128 Mb).
Unfortunately, it's very, very slow (Much more than Primo 1.1).
If someone has an idea...

Hello all,

I updated to iGO Primo 1.2 yesterday and now I don't get overspeed warnings anymore.

I used to get a 'ding' sound warning every 5 seconds (if I was speeding for more than 5 seconds) now I only get the initial speeding warning and no more 'ding' sound every 5 seconds.

Any ideas?

Thanks

I have just downloaded some french poi s they are kml,the instructions (in french) say (i think) to put the kml files in iGO8 :
../content/Userdata/poi
I have /content/poi but no /content/Userdata/poi do i make this folder and put them in there ???

Thank you.

Hi all ,

I am from Qatar and recently installed iGo8 MyWay 8.3.4.117940 on FlyAudio Multimedia GPS system (800 * 480) in my Honda Accord.

I would appreciate if you could kindly help me to how to do the navigation by providing me the step by step instructions to enable me to do so.

I am getting the map on the screen and showing the current location of the car every time, but unable to ...

ok i sorted my issue. i downloaded chas521 - 'Working iGO 8.3 from my device', downloaded teleatlas uk from a different source and hey as soon as i put it on my sd card and placed it in my dvd/sat nav it started to install instantly. went thru the setup and everything is fine except for the gps. at the beginning it stated "Autodetecting GPS" but then showed "Looking for GPS signal" which is good ...

Hi i have some problems with map update .


I have Mio c510 and is instaled on him Igo 8.3.2
I downloaded maps from teleatlas.

all work fine just wen need to find a location have the next problem:

can select country and city but i can't select street, need some basemap for this maps or wat is the problem?

Someone can help me?

ty

To use TMC Pro, you need extra files.
Download and unzip the file, copy the TMC folder in your content folder.

Next you can enjoy the use of TMC Pro in these countries: Hungary, Belgium, Germany, Italy, France, Finland, United Kingdom, Luxembourg, Norway, Sweden, The Netherlands, Slowenia.

Spoiler: Show

:link:

navitotal

I have a Chinese in dash unit, and I am trying to install iGo on it. On the 8.3 I installed I could not get passed the part where you choose a language, I am not sure if it is because my resolution is not correct. On the Primo version I cannot get it to find my gps. I changed the sys.txt file to port 2 and braud 9600 which works for my route66 maps. ...