Installing X5 for R5800

Thu Jan 20, 2011 12:32 pm

Dear All,

I have a R5800 installed with X3, can someone provide X5 and teach me ways to install, thank you.

Thu Jan 20, 2011 1:50 pm

khyer wrote:Dear All,

I have a R5800 installed with X3, can someone provide X5 and teach me ways to install, thank you.

i has sending you already,for installation am not too sure for R5800.
Maybe you can try like this:
1. connect your gps to computer as Mass storage mode.
2. backup your original x3 all entire folders and files.
3. Extract all the zip/rar that i giving you into your device like your original x3.
4. Rename the happy com same like your x3 (Navigator.exe) if not mistaken.
5. insert maps files into MAPS folder.
6. Disconnect your device with computer and run it.

Hope this guide will get work for your pnd.

Fri Jan 21, 2011 12:22 pm

Thank you, everthing was fine except can't turn on junction view and can't exit (just hand when press on exit).

Fri Jan 21, 2011 2:37 pm

khyer wrote:Thank you, everthing was fine except can't turn on junction view and can't exit (just hand when press on exit).

What maps are you using? usually mfm maps have Junction View.........

Sat Jan 22, 2011 3:09 am

i am using MFM maps, i try re-load again and messed up everything, my unit is not working now, will need to send to service centre, is my fault, thanks anyway.